Product Name: ZHX-340C Enameled Wire Paint Scraper Machine | Enameled Wire Paint Removing Machine | Enameled Wire Stripper
Model: ZHX-340C Paint Scraper Machine | Paint Removing Machine | Stripper
Consultation Hotline: 0757-26397858 Mr. Huang 13620805836
ZHX-340C Enameled Wire Paint Scraper Machine | Enameled Wire Paint Removing Machine |Enameled Wire Stripper
ZHX-340C Enameled Wire Paint Scraper Machine | Enameled Wire Paint Removing Machine |Enameled Wire Stripper, adopting the currently advanced Taiwanese electric paint-scraping technology, with adjustable scraping length, suitable for various specifications of enameled wire, convenient and flexible to use. It can quickly scrape off the insulating varnish film on the enameled wire, removing dirt cleanly with a smooth surface. Its superior performance completely replaces traditional manual knife scraping, grinding wheel/sandpaper grinding, chemical corrosion and other paint-removing methods, greatly improving work efficiency and solderability. It is an ideal enameled wire paint-scraping device for the coil manufacturing and maintenance industries of motors, electrical appliances, instruments, transformers, electronics, household appliances, power tools, etc. It integrates an electronic stepless speed regulator, motor and paint-scraping blade, and uses a light and durable micro switch. It features fast scraping speed, high efficiency, simple operation, stable performance, low failure rate and novel, practical design. (Efficiency is several times higher than ordinary models)
Specifications
Machine Model | ZHX-340C | Applicable Wire Diameter | 0.40-4.50mm |
Machine Dimensions | 250 x 185 x 180mm | Voltage | 220v/50Hz |
Motor Power | 120w | Speed | 0--6500r/min Stepless Speed Regulation |
Machine Weight | 8.0kg | Optional Accessories | Tungsten Steel Blade, Alloy Blade |
Stripping Length | 3-70mm | Brand | Foshan Zhenxing |
Installation & Use
Select a suitable blade and install it on the chuck at the front of the machine. Insert an enameled wire into the center of the blade, use a fixing wrench to adjust the chuck so the blade gently clamps the wire, then withdraw the wire. After activating the switch, hold the coil by hand and gently push the wire into the high-speed rotating blade until it reaches the preset stripping length, then carefully withdraw the wire; the stripping is complete. If necessary, the blade aperture can be adjusted by loosening and tightening the chuck to achieve the desired stripping effect. When the machine runs and the blade rotates at high speed, it scrapes off the insulating varnish or oxides on the wire, leaving the stripped wire surface bright and clean.
To set the required stripping length, loosen the chuck's fixing screw and withdraw the chuck to expose the stripping length limit thimble. Adjust the limit thimble via the fixing screw to set and control the stripping length of the enameled wire.